Directions

OSMOSLAY Trigger Bottle.

The OSMOSLAY trigger bottle is a great product to get you started.

All you need to do is decide how much you want to use, the easiest is to pick a volume in 200ml steps, and…

Step 1. Put on suitable Personal protective equipment, you don’t want to get the ultra concentrate in your eyes.

Step 2. Add half of the desired spray volume to the trigger bottle using clean water, use the volume marks on the side of the bottle.

Step 3. Add the required amount of OSMOSLAY, 0.1ml OSMOSLAY per 200ml of water in the total desired volume.

Step 4. Top up the trigger bottle to the desired volume.

Step 5. Spray your target area until the spray runs off, remember bugs like to hide under leaves so spray plants upwards from bottom to top.

OSMOSLAY 5ml Value Refill Pack.

Using the OSMOSLAY 5ml refill could not be easier. The product is identical to what you were supplied in the trigger bottle.

Step 1. Put on your Personal Protective Equipment. (Especially well fitting safety glasses)

Step 2. Add half your total desired spray quantity of clean water to your spray tank/trigger bottle

Step 3. Add the required amount of the supplied 5ml container of ultra-concentrate OSMOSLAY.

Step 4. Top up the spray tank/trigger bottle to the final desired volume. This will mix the ultra-concentrate sufficiently.

The rate of dilution is very important to the activity of OSMOSLAY. If it is too concentrated it will damage the plant. If it is too diluted it will not kill the bugs as effectively. Because of this I recommend using accurate measures of volume.

As OSMOSLAY has only a  two or three day life once diluted, it is understandable that you may want to make a smaller volume. If this is the case we recommend using the accurate dispensing syringe to measure the volumes. Below is a simple dilution table from which you can select the volume you would like to produce. The Simplest way to achieve this is to add the OSMOSLAY to the Jug when half full, and top up to the desired volume with clean water.

Volume desired.	Water (ml).	OSMOSLAY(ml).
500ml (0.5 Litre)	499.75ml	0.25ml
1,000ml (1Litre)	999.5ml	0.5ml
2,000ml (2Litre)	1,999ml	1ml
3,000ml (3 Litre)	2,998.5ml	1.5ml
4,000ml (4 Litre)	3,998ml	2ml
5,000ml (5 Litre)	4,975ml	2.5ml
6,000ml (6 Litre)	5,997ml	3ml
7,000ml (7 Litre)	6,996.5ml	3.5ml
8,000ml (8 litre)	7,996ml	4ml
9,000ml (9 litre)	8,995.5ml	4.5ml
10,000ml (10 Litre)	9,995ml	5ml

 

Once you have diluted a sufficient amount of OSMOSLAY it is ready to use. Please note that it will go stale after 2-3 days and no longer be able to kill pests.

OSMOSLAY is best applied using any traditional garden sprayer or trigger bottle. It is not good practice to use any sprayer that has been used to apply herbicide to apply anything else anywhere near desirable plants, however if you were treating a non plant area like a chicken coop it would be suitable. Apply to runoff to any item/area being treated and repeat at a suitable interval to kill emerging juveniles after egg hatch.

Concentration is critical to the mode of action of this product. Too little, or too much will decrease the effectiveness and may even cause damage.
Wear safety glasses, chemical-resistant overalls, boots, and gloves when mixing. If applied in a situation where spray mist is inhaled, use a respirator (organic vapour and particulate matter).